Unit of competency

Modification History

Release 1. New unit

Application

This unit of competency defines the skills and knowledge required to prepare the materials and carry out routine submerged arc welding (SAW) and applies in a maintenance or manufacturing environment where the weld quality is not required to meet an Australian Standard.

Where welding is required to meet AS 1554 General Purpose or equivalent codes, work health and safety (WHS) regulations and/or licensing requirements Unit MEM05023 Weld using submerged arc welding process should also be selected.

Where the interpretation of technical drawings is required unit MEM09002 Interpret technical drawing should also be selected.

Where the selection and use of engineering measurement is required unit MEM12023 Perform engineering measurements should also be selected.

Where the selection and use of tools is required unit MEM18001 Use hand tools and unit MEM18002 Use power tools/hand held operations, as appropriate should also be selected.

No licensing, legislative or certification requirements apply to this unit at the time of publication.

Band: A 

Unit Weight: 2 

Pre-requisite Unit

Competency Field

Fabrication

Elements and Performance Criteria

Foundation Skills

This section describes those required skills (reading, writing, oral communication and numeracy) that are essential to workplace performance in this unit of competency.

Foundation skills essential to performance are explicit in the performance criteria of this unit of competency.

Range of Conditions

Unit Mapping Information

No equivalent unit.

Links

Companion Volume implementation guides are found in VETNet - https://vetnet.gov.au/Pages/TrainingDocs.aspx?q=b7050d37-5fd0-4740-8f7d-3b7a49c10bb2

Assessment requirements

Modification History

Release 1. New unit

Performance Evidence

Evidence required to demonstrate competence in this unit must be relevant to and satisfy the requirements of the elements and performance criteria on at least two (2) occasions and include:

• following work instructions, standard operating procedures (SOPs) and safe work practices
• identifying and interpreting specifications from sketches and verbal or written job instructions for performing routine submerged arc welding (SAW)
• cleaning and preparing materials for welding to specifications
• setting up welding equipment, including selecting settings and consumables to suit application
• consistently welding materials to specifications
• cleaning welds in accordance with SOPs.

Knowledge Evidence

Evidence required to demonstrate the required knowledge for this unit must be relevant to and satisfy the requirements of the elements and performance criteria and include knowledge of:

• safe welding practices and procedures and use of personal protective equipment (PPE)
• preparatory requirements
• equipment and equipment settings
• flux properties and applications
• weld characteristics.

Assessment Conditions

• Assessors must:

• have vocational competency in performing routine SAW process at least to the level being assessed with relevant industry knowledge and experience
• satisfy the assessor requirements in the Standards for Registered Training Organisations 2015 or its replacementand comply with the National Vocational Education and Training Regulator Act 2011, its replacementor equivalent legislation covering VET regulation in a non-referring state/territory as the case requires

• Where possible assessment must occur in operational workplace situations. Where this is not possible or where personal safety or environmental damage are limiting factors, assessment must occur in a sufficiently rigorous simulated environment that reflects realistic operational workplace conditions. This must cover all aspects of workplace performance, including environment, task skills, task management skills, contingency management skills and job role environment skills
• Conditions for assessment must include access to all tools, equipment, materials and documentation required, including relevant workplace procedures, product and manufacturing specifications
• Assessment processes and techniques must be appropriate to the language, literacy and numeracy requirements of the work being performed and the needs of the candidate.

Links

Companion Volume implementation guides are found in VETNet - https://vetnet.gov.au/Pages/TrainingDocs.aspx?q=b7050d37-5fd0-4740-8f7d-3b7a49c10bb2